PD-1902 Ranger DVR: Configure the Displayed Output

The Ranger DVR will, by default, display cameras one (1) through eight (8). However, the DVR's configuration options allow you to easily select the specific connected cameras to display. 

Connect to the Ranger's Wi-Fi

1. Power the vehicle on and verify that the DVR’s status LED is lit solid green.
   • The event marker button LED can also be used as an indicator.
   • Accessory power is enough to power the Ranger.  
2. On a smart device, navigate to the Wi-Fi options, locate and select the Ranger’s network.  
   • The default Wi-Fi name will begin with “PV_Ranger…” and the last six (6) characters are unique to the DVR unit.
3. Type in the Wi-Fi password when prompted.
   • The default Wi-Fi password is doesitall
4. Open a web browser on the smart device and type 192.168.1.254  to open the Ranger’s webpage.

If you have any issues connecting to the Ranger DVR, follow the instructions in this article. 
 

Configure the Display Settings

1. Open the "Settings" menu in the top right corner.
   
2. From the menu, click on "Display." 
   
   • This might prompt a sign-in pop-up. Type the login credentials and click [Sign in].
     • Default username: admin
     • Default password: doesitall
       
3. On the "Display Settings" page, click on the toggle under "Camera View(s) Displayed on Monitor. " 
   
   • The highlighted "Camera View(s)" under the toggle are the ones selected as the DVR's display output. 
     
4. Click any of the cameras that shouldn't display, leaving only the desired cameras highlighted in blue.