DVR Status Light Explanations
|4G||AMBER||Normally OFF, this indicates when the DVR is connected to a 4G network. This light requires the DVR to be configured with the optional 4G Modem.|
|STATUS||GREEN/RED||Solid green indicates the DVR is on and operating/recording normally. Flashing green indicates the DVR is still booting up or is operating properly, but is not set to record. Flashing red indicates the system is operating but cannot record; this can be due to a missing or full storage device or DVR issue.|
|PWR||GREEN||Solid green indicates DVR is on. Blinking with green RUN indicates there is no ignition signal and DVR is in the time-delayed shutoff mode.|
Blinking indicates DVR is on. Blinking with green PWR indicates there is no ignition signal and DVR is in the time-delayed shutoff mode.
|WIFI||AMBER||Blinking amber indicates the DVR is connected to a Wi-Fi network.|
Blinking amber indicates the number of cameras configured to record that are not recording, this requires configuration to be accurate.
|SD||RED||Flashing indicates data is recording to SD card. Solid indicates the SD card is present, but no data is being recorded. OFF indicates no SD card is present.|
|SSD||RED||Flashing indicates data is recording to the solid-state drive. Solid indicates the solid-state drive is present but is not recording. OFF indicates there is no solid-state drive present.|